Lexland Trim Cover Installation Guide
Toyota owners often want to improve both protection and style inside their vehicles. The ABS Door Trim Cover is a practical accessory that helps reduce scratches and gives the door panels a cleaner look. This guide will walk you step by step through the installation process.
Related Accessories
While upgrading your Tacoma with door trim covers, you might also find these compatible accessories useful:
1、Tacoma Front Center Grille Grill Inserts Strips ABS Decorative Trim for Toyota
2、Tacoma Window Deflectors ABS Window Visors Rain Guards for Toyota
3、4Runner Door Trim Strip ABS Front & Rear Upper Door Panel Protector Interior Trim Cover
4、Tacoma Door Trim Cover ABS Front & Rear Door Protector Interior Trim Strip for Toyota
Preparation Before Installation
Before starting, make sure the environment and tools are ready:
- Environment: Work indoors or in a clean area, avoiding dust and direct sunlight.
- Temperature: Best to install in conditions above 15℃ (59°F). If colder, use a hairdryer or heat gun to gently warm the surfaces.
- Tools Needed: Clean cloth, alcohol or isopropyl wipes, plastic squeegee, hairdryer (optional).
- Check the Parts: Confirm the number and shape of trim covers match your doors, and that the adhesive tape is intact.
Tip: Do a test fit by placing the trim on the door to confirm alignment before installation.
Installation Steps
1. Cleaning and Positioning
- Wipe the target surface with alcohol or isopropyl to remove dust and grease.
- Position the trim on the door to confirm placement and alignment.
2. Heating (Optional)
- In colder environments, use a hairdryer to gently warm the adhesive side of the trim and the door surface. This improves adhesion.
3. Applying the Trim
- Start peeling off the adhesive backing from one end.
- Stick the trim gradually while aligning it with the door lines.
- Use a plastic squeegee to press from the center outward, removing air bubbles.
4. Securing and Adjusting
- Once applied, press firmly along the entire trim to ensure proper adhesion.
- Check for any lifted edges. If necessary, apply gentle heat and press again.
Notes and Common Issues
- Not sticking well? The surface may not be clean enough, or the temperature is too low. Clean thoroughly and reapply with heat.
- Misaligned? If the trim has just been applied, carefully peel it back and reposition. Avoid removing once the adhesive has fully set.
- Edges lifting? Apply local heat and press again. Replace adhesive tape if needed.
Maintenance and Checks
- Avoid frequent door use or car washing within 24 hours of installation.
- Periodically check if the edges remain secure and clean the surface.
- Do not use strong acid/alkaline cleaners or high-pressure water directly on the trim edges.
Conclusion
Installing the Tacoma Door Trim Cover is straightforward. The key steps are thorough cleaning, suitable temperature, and careful application. By following this guide, you can easily complete the installation and enjoy both added protection and style for your Tacoma’s interior.
